Installation and connection
Doc. no. BA012498_03
26 / 112
GB
Disconnect the device from the supply voltage.
Unscrew the cover to access the “DALI Power” switch.
Set the switch to “ON”.
Fasten the cover in place.
Reconnect the device to the supply voltage.
During the initialisation phase that follows, the device reads the
switch position.
The bus voltage supply is activated.
4.3.8.2 Connecting SmartDrivers in parallel
Before connecting, ensure that the DALI bus power supply settings are
correct:
• For up to five Boxes the “DALI Power” switch should be set to “ON”.
If you connect fewer than five boxes in parallel, the “DALI Power”
switch must be set to “ON” for all devices.
How to connect the Light Control Boxes:
Insert the cable provided with both Light Control Boxes into one of
the sockets labelled “C0”.
C0
C0
C0
C0
SENSOR
SENSOR
Connecting Light Control Boxes in parallel
If you subsequently connect a Light Control Box in parallel to a
preset Light Control Box, the devices save different settings. If
this is the case, reset the preset Box to factory settings and re-en-
ter the settings for the connected Light Control Boxes.
The Box can be restored to factory settings using the universal
remote control (see Chapter 8.10 on page 71) and using the app
(see Chapter 13.1.8 on page 94).
Parallel con-
nection after
installation
