Summa Series Servodrive Product Manual
Wiring and Connecting
Document Version: V1.01
(Dec, 2019)
© 2019 ESTUN Automation Co., Ltd. All right reserved.
3-9
Step 4
Crimp the cable that has been inserted into the ferrule, and cut off the cable conductor portion protruding
from the ferrule (The allowable protruding length after cutting should not be more than 0.5 mm).
Figure 3-5
Crimp the cable
Cut off the
protruding
portion
Step 5
Insert the crimped cable into the connection terminals directly until the cable is not easily pulled out (A
slight pull is allowed).
Step 6
Make all other connections in the same way.
Step 7
To change the wiring, pull the cable out of the connection terminals.
Use the flat-blade screwdriver to press down the spring button corresponding to the terminal, and then
gently pull out the cable.
Figure 3-6
Pull out the cable
Press down the
spring button
Pull out the
cable gently
Step 8
When you have completed wiring, attach connection terminals to the Drive.
NOTE
The above wiring procedure is also applicable to the Motor Terminals.
