Esko Kongsberg C series, Руководство пользователя

Страница: 56 / 268

10
Kongsberg C-series
Procedure:
1. If the table is equipped with a Conveyor Belt , move the belt junction away from the table
surface.
2. Execute the Map Table Top function.
3. Follow the instructions given by the wizard.
Note:
iPC 2.1 : The mechanism of compensating Z height during cutting, based on table top mapping,
has been disabled when cutting underlay has been measured to be more than 5mm.
This level is normally reached when milling on top of milling mat and conveyor belt.
This exception was introduced long time ago, before using conveyor belts.
At that time, a (MDF) plate was used as milling underlay. The plate was milled in order to make
a perfectly compensated underlay for milling.
As this function is not used anymore, and conveyor belts break the 5 mm limit, iPC now always
compensate based on table top mapping.
A registry setting is available to enable the old behavior.
10.8. Calibrate Foot on Measuring Station
Machine Connection -> Machine Configuration -> Installation _> Calibrate
Measuring Pad
Use this wizard to calibrate the height level of the Measuring Station .
Typical use is after maintenance or repair; to ensure the tool height measuring system works
properly.
Procedure:
1. Press the Calibrate Foot .
2. Follow the instruction given by the wizard.
3. Repeat this procedure after maintenance on the Traverse , Carriage or Measuring Station .
10.9. Reference Points and Coordinate System
Reference Points settings is maintained from:
Menu Bar
->
Edit
->
Options
...->
Reference Points
56