Esko Kongsberg C series, Руководство пользователя

Страница: 142 / 268

12
Kongsberg C-series
The supplied milling bit is heavily unbalanced
and should not be run faster than 20.000 RPM
to avoid excessive wear to the milling spindle!
This also means that you should not use this
bit when warming up the milling spindle as
the warm up sequence exceeds 20.000rpm.
Braille Tool setup
In order to create high quality consistent braille patterns you should perform Tool Height and
Tool Offset calibrations.
Note: It is crucial that the Tool Height is correctly set before running this tool.
The nominal value is Tool Height = Material Thickness .
Meaning, if the material is 6 mm thick, the nominal height setting should be -6 mm (minus 6
mm).
Tool Offset adjustment
Machine Connection -> Tool Configuration
1 Load the Braille Tool with black spheres.
2 Cut a piece of double sided tape measuring approximately 20x20 mm /
0.8x0.8 in. and stick it to the surface of the working area. Preferably the milling
underlay or your selected substrate. It is important that the piece of tape fits
within the hole in the measuring foot with good margins.
3 Insert the Braille Tool in the MultiCUT tool head.
4 Open up the Tool Adjustment dialog.
5 Select Braille Tool and press Adjust Active Tool …
6 Select Tool Offset Adjustment and press Next .
7 Jog the tool head to the position of the tape so that the laser dot is placed in
the middle of the piece of tape.
8 Press Start . The machine will measure the material thickness and dispense a
sphere onto the tape piece.
If the
Laser Spot is offset from the sphere, jog the tool head until the Laser
Spot is placed exactly on top of the sphere.
142