Esko Kongsberg C series, Руководство пользователя

Страница: 102 / 268

12
Kongsberg C-series
Router bits are very sharp – handle with care.
Never touch a rotating bit. Ensure the warning lamp is dark, and also observe that the
bit is not rotating before approaching the bit.
Always insert a dummy bit before dismounting a tool head from the machine.
High temperatures
Be aware it is normal that the HPMU appears to be hot during operation.
Clean surface
Keep the table and material surface clean, free from obstacles.
12.8.5. Precautions
Spindle Motor Power Consumption Supervision
Machine Panel -> Spindle Power
The HPMU spindle is prepared for continuous operation between 0 – 100 % Watt.
A power load of 70-80% will allow good working conditions for the
Spindle Motor .
Too high Spindle Power consumption indicates critical conditions for the motor and
immediate actions should be taken:
1. Use correct and sharp milling bit.
2. Use correct RPM for the actual bit and material.
3. Reduce the X/Y speed.
If the motor is running above a critical limit, the execution will stop and a message is displayed.
Use of Non-Balanced Bits
One-flute bits are by nature Non-Balanced ,
and may destroy the Spindle if used wrong.
Therefore, one-flute bits with cutting
diameters above 4 mm, 5/32 inch, must be
run with a maximum RPM of 40.000 (HPMU)
102