Esko Kongsberg C series, Руководство пользователя

Страница: 197 / 268

18
Kongsberg C-series
1 - Gantry
The Gantry is the entire horizontal moving assembly.
The Carriage Beam moves vertically up and down within the Gantry.
2 - Carriage Beam
The carriage beam is the vertical moving beam that carries the suction cup arms.
3 - Suction Cup Arms
The suction cup arms are attached to the carriage beam and can be adjusted horizontally
across the carriage beam.
The suction cups can be adjusted horizontally on the suction cup arms.
4 - Suction Cup Compensators
The suction cup compensators carry the suction cups and have approximately 100mm of
vertical travel.
The compensators allow all of the suction cups to come in contact with the surface of the top
board even on warped boards or uneven stacks of boards.
5 - Plunger Sensor
The plunger sensor is a proximity switch that detects a target disk on the moving compensator.
The target disk moves up when the suction cup contacts the top board on the stack. This is the
method used to determine the height of the stack of boards and the top surface of the support
table.
6 - Support Table
The i-BF picks the top board off of the stack and transfers the board onto the support table.
7 - Support Table Roller
A roller is mounted on the support table at the board stack side of the table.
The roller helps to guide and transfer flexible materials onto the support table.
The roller is also used when the Esko roll unit is in service.
The roll material rolls over the support table roller, over the support table, and onto the cutter
conveyor.
8 - Electrical Enclosure
The electrical enclosure houses all of the electrical power and control devices.
The Main Power disconnect and Power On/Off pushbuttons are located on the door of the
electrical enclosure.
197