Endress+Hauser Proline Cubemass C 100 HART, Руководство по эксплуатации

Страница: 88 / 126

Diagnostics and troubleshooting Proline Cubemass C 100 HART
88 Hauser
Diagnostic
number
Short text Remedy instructions Status
signal
[from the
factory]
Diagnostic
behavior
[from the
factory]
Diagnostic of configuration
410 Data transfer 1. Check connection
2. Retry data transfer F Alarm
411 Up-/download active Up-/download active, please wait C Warning
431 Trim 1 Carry out trim C Warning
437 Configuration
incompatible 1. Restart device
2. Contact service F Alarm
438 Dataset 1. Check data set file
2. Check device configuration
3. Up- and download new
configuration
M Warning
441 Current output 1 1. Check process
2. Check current output settings S Warning
1)
442 Frequency output 1. Check process
2. Check frequency output
settings
S Warning
1)
443 Pulse output 1. Check process
2. Check pulse output settings S Warning
1)
453 Flow override Deactivate flow override C Warning
484 Simulation failure mode Deactivate simulation C Alarm
485 Simulation measured
variable Deactivate simulation C Warning
491 Simulation current output
1 Deactivate simulation C Warning
492 Simulation frequency
output Deactivate simulation frequency
output C Warning
493 Simulation pulse output Deactivate simulation pulse
output C Warning
494 Switch output simulation Deactivate simulation switch
output C Warning
495 Simulation diagnostic
event Deactivate simulation C Warning
537 Configuration 1. Check IP addresses in network
2. Change IP address F Warning
590 Special event 3 Contact service F Alarm
591 Special event 7 Contact service F Alarm
592 Special event 11 Contact service F Alarm
1)
Diagnostic of process
803 Current loop 1. Check wiring
2. Change I/O module F Alarm
830 Sensor temperature too
high Reduce ambient temp. around the
sensor housing S Warning
831 Sensor temperature too
low Increase ambient temp. around
the sensor housing S Warning
832 Electronic temperature
too high Reduce ambient temperature S Warning
1)
833 Electronic temperature
too low Increase ambient temperature S Warning
1)