Endress+Hauser Proline Cubemass C 100 HART, Руководство по эксплуатации

Страница: 62 / 126

Commissioning Proline Cubemass C 100 HART
62 Hauser
Parameter overview with brief description
Parameter Description Selection / User entry Factory setting
Operating mode Define the output as a pulse, frequency or
switch output. • Pulse
• Frequency
• Switch Pulse
Switch output function Select function for switch output. • Off
• On
• Diagnostic behavior
• Limit
• Flow direction check
• Status Off
Assign diagnostic behavior Select diagnostic behavior for switch output. • Alarm
• Alarm or warning
• Warning
Alarm
Assign limit Select process variable for limit function. • Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
• Carrier mass flow
• Density
• Reference density
• Dynamic viscosity
• Concentration
• Kinematic viscosity
• Temp. compensated
dynamic viscosity
• Temp. compensated
kinematic viscosity
• Temperature
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Measuring tube damping
Mass flow
Assign flow direction check Select process variable for flow direction
monitoring. • Off
• Volume flow
• Mass flow
• Corrected volume flow Mass flow
Assign status Select device status for switch output. • Partially filled pipe detection
• Low flow cut off Partially filled pipe detection
Mass flow unit Select mass flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Volume flow unit Select volume flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• l/h
• gal/min (us)
Unit totalizer Select process variable totalizer unit. Unit choose list kg
Switch-on value Enter measured value for the switch-on
point. Signed floating-point number 0 kg/h
Switch-off value Enter measured value for the switch-off
point. Signed floating-point number 0 kg/h
Switch-on delay Define delay for the switch-on of status
output. 0.0 to 100.0 s 0.0 s