Function parameter schedule graph
37
1: The lowest priority level
Tens digit: Keypad adjustment of display
setting (under speed control mode)
0: Display setting frequency
1: Display setting rotation speed
F09
-
On-off , Analog output function parameter group
Function
code
Name
Set range
Min.
unit
Factory
default
Modifi
-cation
F09.00 Open
collector
output terminal Y1
output setup
0:Terminal unused
1:Operation(RUN)
2:Inverter running forward
3: Inverter running reverse
4:DC brake
5:Run prepare finish (Busbar voltage normal, fault
free, no run forbid,receival of run command’s status)
6:Stop command indication
7:No current arrived
8:Overcurrent arrived
9:Current1 arrived
10:Current2 arrived
11:No frequency output
12:Frequency arrival signal(FAR)
13:Frequency level detect signal 1(FDT1)
14:Frequency level detect signal 2(FDT2)
15:Output frequency arrival upper limit(FHL)
16:Output frequency arrival low limit(FLL)
17:Frequency 1 arrival output
18:Frequency 2 arrival output
19:Overload pre-alarm signal(OL)
20:Undervoltage lockout stop (LU)
21:External fault stop(EXT)
22:Fault
23:Alarm
24:Simple PLC operation
25:Simple PLC section operation finish
26:Simple PLC circle operation finish
27:Simple PLC operation stop
28:Traverse frequency high and low limit
29:Setup length arrival
30:Internal counter final value arrival
31:Internal counter designated value arrival
32:Internal timer arrival---output 0.5s valid signal on
arrival
33:Operation stop time finish
34:Operation arrival time finish
35:Setup run time arrival
36:Setup power on time arrival
37-40: Reserved
41:Communication provision
42: Torque control speed limiting
43:Torque arriving output
44: Reserved
45: The brake logic 1(Brake in the process of
switching forward and reverse )
46: The brake logic 2( not brake in the process of
1
0
×
ENC
