30/112
WL31/WL31TG
4.1.7 TX30WL/3 OR TX30WL/5 REMOTE CONTROL
1. Open the remote control by unscrewing the screws situated on the back of it.
2. Insert the supplied battery according to the correct pole positions. If you want, it is possible to personalize the
keys already during this phase, using the specific labels as explained on page 34.
3. All the LEDs turn on green for about 5 seconds, after the LED 1 flashes green (2 flashes every 4 seconds) to
show the “unprogrammed status”.
4. Press button 2 of the remote command. LED 1 will flash with green light to indicate the informations
transmission to the control panel.
5. The control panel, after recognizing the information and acquiring the device, makes a series of acoustic
signals (“beeps”) and the display shows the message «TXnn Acquisition - Remote control», where nn
indicates the address given to the device.
Advice n. 1
: take note of this address and write it on an adhesive label to place on the back of the
remote control (this will be useful during the configuration phase). Note down the same address on the
programming tables situated at the end of this manual.
Advice n. 2
: if the control panel does not acquire the device, carry out its reset according to the
instructions contained in the DEVICE RESET paragraph.
6. The remote control, after having been recognized by the control panel, switches on the LED 1 in green for 3
seconds and after turns off. The remote control is ready, under normal working conditions. If instead the LED 1
turns on red, it means that the remote control has not been recognised.
4.1.8 TX31WL/3 OR TX31WL/5 REMOTE CONTROL
1. Open the remote control by unscrewing the screw situated on the back of it.
2. Insert the supplied battery according to the correct pole positions. If you want, it is possible to personalize
the keys already during this phase, using the specific labels.
3. All the LEDs turn on green for about 5 seconds, after the LED 1 flashes green (2 short flashes every 4
seconds) to show the “unprogrammed status”.
4. Press button 2 of the remote command. LED 1 will flash with green light to indicate the informations
transmission to the control panel.
5. The control panel, after recognizing the information and acquiring the device, makes a series of acoustic
signals (“beeps”) and the display shows the message «TXnn Acquisition - Remote control», where nn
indicates the address given to the device.
Advice n. 1
: take note of this address and write it on an adhesive label to place on the back of the remote
control (this will be useful during the configuration phase). Note down the same address on the
programming tables situated at the end of this manual.
Advice n. 2
: if the control panel does not acquire the device, carry out its reset according to the instructions
contained in the DEVICE RESET paragraph.
6. The remote control, after having been recognized by the control panel, switches on the LED 1 in green for
3 seconds and after turns off. The remote control is ready, under normal working conditions. If instead the
LED 1 turns on red, it means that the remote control has not been recognised.
