92/112
WL31/WL31TG
12.2.4 KP30WL KEYBOARD
1. Open the keyboard by slightly rotating the flap situated on the lower side with a screw driver.
2. Remove the batteries, wait for at least 10 seconds and reinstall them, according to the correct polarity.
3. All the LEDs turn on for about 5 seconds.
4. During this phase, press the keys 2 and 5 together: the red LED flashes (see figure); keep the keys pressed
until the red LED becomes constant
5.
Release the keys: the LED becomes green and flashes to show the “not programmed” status.
6. It is now possible to acquire the keyboard again.
12.2.5 TX30WL OR TX31WL REMOTE CONTROL
1. Open the cover.
2. Remove the battery, wait for at least 10 seconds and reinsert it.
3. All the green LEDs turn on for about 5 seconds. During this phase, press the key 2 and 3 (for three-key models)
or 2 and 5 (for five-key models) together and keep them pressed until the LED 1 becomes red and constant.
4. Release the keys. Once the LED turns off, the remote control carries out the initialising cycle again (all LEDs on)
and then enters into the “not programmed” status. It is now possible to acquire the remote control again.
