CPX230NWB ALARM CONTROL PANEL – INSTALLER MANUAL
83 / 144
EN
User can configure remote controllers, to suit his needs. Remote controller has to be
assigned to one of the previously added users (or administrator) –
User
column.
Controller’s buttons can be assigned to the actions of the Alarm Control panel. In order to
assign a button to the action, one has to select the desired action from the drop-down
menu in the corresponding
Button
column – columns from
Button 1
to
Button 4
. Remote
controller can have less then 4 buttons, in that case, additional
Button
columns should be
left with the None option selected.
NOTE: The selected user number must be activated by the
Administrator. For this user number should be generated an access
code.
“Arm” function is fully arming the system.
“Disarm” function is disarming the system.
„Alarm” function is triggering an alarm with audible signal.
„Silent alarm” function is triggering an alarm without audible signal.
Switch on/off output 1, 2 and 3 functions allow control of any external devices.
„Ambulance” function works the same way as „HELP” button on the keypad, ie generates
a medical alarm.
“Arm immediately” function allows fully arming the system without counting down time
for exit (if is set).
Alarms from remote control can be generated regardless of whether or not the partition is
armed.
For normal and silent alarm can be sent a message to the monitoring station, depending
on the configuration of the control panel.
The control panel allows you to assign remote control buttons to various functions. It is
possible to configure different alarm button but the manufacturer recommends assigning
a button
to normal alarm, and
to silent alarm
Configuration for pilots should be automatically write to the control panel. Nevertheless
the Manufacturer recommends that after adding and configuring the pilot/s information
has been sent by pressing the red arrow "Write" from the Quick Access bar (or
"Operations" -> "Write"). A window will appear, as in the chapter on wireless detectors.
You have to select third checkbox “Write Wireless Devices (only for CPX)” ", enter the
service code and press “Write”.
