CPX230NWB ALARM CONTROL PANEL – INSTALLER MANUAL
65 / 144
EN
Enter server address, server port and APN. When clicking OK, the system will send
entered parameters to the equipment (SMS).
Wait until the equipment reports to the server (in Equipment tab, it will be marked
green).
Start the software and define the options of the equipment (for description, please
refer to chapter 7).
Select Send function. The window will appear where you have to select the
previously defined remote connection (chapter 5.3.1.5.2.). Copy the settings into the
memory of the equipment.
Close the configuration wizard’s window after you finish the data input.
The equipment is ready for data transmission.
5.4.2.2.
Reprogramming of equipment
As access parameters to GPRS network and OSM.Server are defined in the equipment,
you can proceed with programming any time.
If the equipment is installed in a secured facility, i.e. it has a SIM card inserted and it is
connected to power supply, the programming procedure in the following:
Start the configuration wizard software and define the options of the equipment (for
description, please refer to chapter 6.).
Select Send function. The window will appear where you have to select the
previously defined remote connection (chapter 5.3.1.5.2.). Copy the settings into the
memory of the equipment.
Close the configuration wizard’s window after you finish the data input.
The equipment is ready for data transmission in accordance with new settings.