CPX230NWB ALARM CONTROL PANEL – INSTALLER MANUAL
70 / 144
EN
is 0000. It should be changed at first equipment start-up (programming). The code can
be composed of from four to seven digits.
6.1.5.2.
Installer code
Installer’s code is used for equipment programming process using KP32 keypad. Default
factory setting is 2222. It should be changed at first equipment start-up (programming).
The code can be composed of from four to seven digits.
Installer’s code could be read and change remotely via OSM.Server Console or by sending
SMS message. In case of reading Installer’s code via OSM.Server Console, please send
following Custom command:
GETPARAM=3,1
The answer with current Installer’s code appears in the bottom part of the Console
window.
Installer’s code could be changed via OSM.Server Console. In such case, please send
following Custom command:
SETPARAM=3,1,new_code
where new_code should contain from 4 up to 7 digits.
6.1.5.3.
SIM Card PIN code
Since the equipment uses GSM network for its operation, it is necessary to obtain a SIM
card from a mobile network operator. You have to set a PIN code of a SIM card dedicated
for operation in particular equipment before its first use. It is necessary for automatic
start up of the system. In case you have a card without the PIN code, you can enter any
value in that box, e.g. 0000.
If you enter incorrect PIN code, the system will not start after inserting the card and
switching the power supply on and you will not be able to use the card until you enter the
PUK code (using any GSM phone).
Default factory PIN code entered in the equipment is: 1111.
