Docomo mova SH506iC, Руководство пользователя

Страница: 288 / 588

286
Setting i-mode
View
ing
Inform
atio
n Usin
g i-m
ode
You can enable i-mode service when you have registered for it separately.
If you registered for i-mode service when you purchased your mova, these settings are not
needed.
4
Enter the host name.
A new host registration is displayed as “Host
○
”.
To delete the host name that is displayed, press
c
for at least 1 second.
You can enter up to 8 full-pitch (16 half-pitch) characters.
5
Press
t
, and then enter the host number.
You can enter up to 11 digits.
6
Press
t
, enter the host address, and then press
t
.
Only half-pitch alphanumeric characters and symbols can be entered.
Up to 30 half-pitch characters can be entered.
Note Settings do not need to be changed if DoCoMo i-mode services are being used.
“
N
ドコモ
” displayed in the host selection screen will differ as shown below, depending on
the area where you are registered for i-mode.
“DoCoMo Hokkaido”, “DoCoMo Tohoku”, “DoCoMo”, “DoCoMo Tokai”,
“DoCoMo Hokuriku”, “DoCoMo Kansai”, “DoCoMo Chugoku”, “DoCoMo Shikoku”,
“DoCoMo Kyushu”
The default connection information cannot be changed.
To reset registered information
S
Select the host for which you wish to reset registered information in step 2.
T
Press
3
(Reset host).
U
Enter your terminal security code (4 digits).
When the current set host is reset, the host returns to “
ドコモ
”.
Setting to Enable i-mode <i-mode Connection>
Ki914L
1
In the stand-by, press
t
and select , press
t914
(
R
-mode connection).
“i-mode connection” is set to “ON”, and i-mode is enabled.
Note Even if you are not subscribed to the i-mode service,
R
lights when “i-mode connection” is
set to “ON”. It will switch to “OFF” as you attempt to connect to i-mode.
e̲n500.book Page 286 Tuesday, August 9, 2005 1:15 PM