Docomo mova SH506iC, Руководство пользователя

Страница: 210 / 588

R
e
stric
ting M
ob
ile P
hone
O
p
erati
ons
208
Preventing Use by Another Person
You can set the mova Keypad dial lock function by calling your mova from a pre-
registered telephone or payphone a specific number of times within a specific amount of
time (for example, 3 times in less than 5 minutes).
Remote keypad lock only sets when a call fulfilling all of the following pre-registered and
preset requirements have been met.
Operations are performed in the same way even when Keypad lock is already set.
You cannot use a remote operation to disable Keypad lock. To disable Remote keypad lock,
refer to “To disable” of “Setting Keypad Lock” on
n
P.207.
Depending on the type of image, “Keypad lock” may not display when the stand-by display
image is set or during calendar display.
Setting Remote keypad lock
Kt624L
The default setting is “Disable” (OFF), number of Received calls “5 times”, and monitoring
time “3 minutes”.
Note While Keypad lock is set...
You can do the following when receiving a call.
Answer a call using
s
or Any key answer
Set Quick silent using
#
Recorded message answering (when this is already set)
Missed call display
You cannot do the following when receiving a call.
Manual call transfer using
t#
or
t*
Recorded message answering using
tt
You can do the following during a call.
End a call by pressing
H
Adjust earpiece volume using
u
Send push signals via keypad
Setting Keypad Lock Remotely <Remote Keypad Lock>
Category Saved/Set contents
License number
You can save up to 3 phone numbers to be used for remote operation.
You can also set your mova to allow this operation to take place from a payphone.
# of rcvd calls
Set the number of Received calls (3 to 10 times) within the monitoring time that
will enable Remote keypad lock. The default setting is “5 times”.
Monitoring
Set the time (1 to 10 minutes) during which the call number count occurs after a
call has been received from a license number. The default setting is “3 minutes”.
1
In the stand-by, press
t
and select , press
t624
,
and then enter your terminal security code (4 digits).
Each entered digit is displayed as “
b
”.
The Remote keypad lock screen is displayed.
2
Press
1
(ON).
To disable
Press
2
.
e̲n500.book Page 208 Tuesday, August 9, 2005 1:15 PM