Detnov CAD-250, Руководство по установке

Страница: 70 / 84

ENG
70
On the FRONT PLANE of each support, starting from the left, fit the
necessary ties for the zone line cables that will enter the control panel
at each level. Proceed in the same way with the remaining supports.
On the REAR PLANE of each support, fit the cable lines that will continue
to the lower control panels, starting with the cable lines that go to the
control panel lowest down. Each hole allows the OUTPUT line and the
RETURN line of a loop to pass through it.
Once the cables that go to the lower control panels are fitted, fit the
cable lines that will enter the control panel installed at the current level,
using the ties that you installed previously.
In this example, you can see that 8 cables will enter the control panel
of the current level (OUTWARD and RETURN of 4 LOOPS), whereas
8 zones (16 cables) run through the REAR PLANE of the support,
which will run down to the lower levels.