Detnov CAD-250, Руководство по установке

Страница: 42 / 84

ENG
42
4. START-UP
4.1. MAIN PANEL
The main panel is located on the left part of the door and consists of a
series of lights and basic controls that let you know what is happening
in the system at a glance.
The European standard EN54-2 sets out the requirements for this
panel, including the buttons, visual and audible indications and their
behaviour.
1
2
3
4
5
No. Area Description
1
GENERAL LEDS
General state indicators in accordance with the UNE
23007-2 and EN54-2 requirements
2
GENERAL CONTROLS
Mandatory general control buttons in accordance with the
UNE 23007-2 and EN54-2 standards.
3
LOCK
Permits or blocks access to the inside of the control panel.
(Acts as access level 3).
4
10” TOUCHSCREEN
Main interface of the CAD-250 control panel.
5
PRINTER
Only available on CAD-250-P: It allows you to obtain a
paper copy of the system's events. This device cannot be
installed as an option.
4.2. GENERAL LEDS
No. Condition
Colour/
status
Description
1
SERVICE
Green
Permanent
The control panel is powered and works correctly
2
ALARM
Red
Permanent
The fire alarm condition is active from any initiator
device in the loop
3
CANCEL
Amber
Permanent
An element of the system is disabled (device,
group, etc.) or there is a delay applied. Normally
active together with another general indicator
4
FAULT
Amber
Intermittent
Indicates a fault in the system from a loop element,
communication ports or the control panel; normally
active in combination with other general indicators
5
TEST
Amber
Permanent
An element of the system, area or zone is in test
mode.
6
OUT OF
SERVICE
Amber
Permanent
There is a mains network power failure and the
battery voltage is less than 20 V.
7
SYSTEM
FAULT
Amber
Intermittent
There is a power supply issue caused by the
network, batteries or fuses
1
4.2. GENERAL
LEDS
2
3
4
5
6
7
8
9
10
11
12
13
14
15
4.3. GENERAL
CONTROLS
16 17 18 19