Detnov CAD-250, Руководство по установке

Страница: 49 / 84

49
ENG
5.5.1. Device information and configuration
From the device list and when selecting one of them, you will have
access to its detailed fields, which will allow you to consult or configure
its operation.
The navigation bar identifies the loop number and device that you are
in currently.
Descriptive term Definition
DEVICE Identified by the loop number and physical address of the device.
The device description is also shown here when it is assigned.
To change the description, touch the description field and a virtual
keyboard will appear
ZONE It shows the zone assigned to the device.
By default:
Zone 1 . It shows the description of the zone if it has been
assigned
To change the zone assignment, touch the Zone field and a virtual
keyboard will appear; enter the corresponding zone number.
If the chosen zone number does not exist, the zone will be created
automatically.
AREA It shows the area assigned to the device.
By default:
Area 1 . It shows the description of the zone if it has been
assigned
To change the area assignment, touch the Area field and a virtual
keyboard will appear
If the chosen area number does not exist, the area will be created
automatically.
TYPE It identifies the type of device found or assigned. Detector, manual
call point or module.
MODE It indicates the ZONE or AREA mode to which the device is assigned.
This field can only be modified from the SECTORISATION section of
the main menu. The modes of a zone or area can be ENABLED ,
DISABLED or TEST
STATUS Condition of the device:
Green: Normal or in standby
Red: Alarm
Amber: Fault
Blue: Technical event active
ADDRESSABLE
VALUE
It shows the analog value corresponding to the device status and the
sensor reading at that time
By pressing Loop on the navigation bar, a pop-up table will open, giving
you the option to change the loop selection.
By pressing
Devices on the navigation bar or the back button, you will return
to the device list.