Installing the 1.8-inch solid state drive
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the sled from the enclosure.
Steps
1.
Connect the SATA power and data cable to the solid state drive (SSD).
2.
Slide the SSD with the SATA power and data cable into the SSD drive holder.
3.
Press the SSD down until the drive lock clicks into place and secures the SSD.
Figure 28. Installing the 1.8-inch SSD
NOTE: Ensure that the hard drive is installed with the label facing up. This is to ensure that the hard drive connector
is aligned with the connector on the cable.
Next steps
1.
Install the sled into the enclosure.
2.
Follow the procedure listed in the After working inside your system section.
74
Содержание PowerEdge C6320p
