Dell N1100-ON, Справочное руководство

Страница: 1312 / 2332

Layer 3 Routing Commands
1312
only valid for OSPF originated routes. Successive redistribute commands
are additive. Use the no form of the command to disable redistribution of
a route source.
• route-map map-tag — (Optional) A route map can be used to filter
redistributed routes by destination prefix using a prefix list.
Default Configuration
BGP redistributes no routes by default. When BGP redistributes OSPF
routes, it redistributes only internal routes unless the match option specifies
external routes.
Command Mode
IPv6 Address Family Configuration mode
User Guidelines
The distribute-list out command can also be used to filter redistributed
routes by prefix. Either a redistribute route map or a distribute list may be
configured, but not both.
Successive invocations of the
redistribute command are additive. The
redistribute command does not overwrite previous redistribute command
configuration or the default configuration. Use the no redistribute command
to remove the redistribution of internal or external routes.
A default route cannot be redistributed unless the
default-information-
originate command is given. The configured metric value is specific to the
routes distributed. Use the default-metric command to configure a default
metric for all redistributed routes.
In IPv6 address family configuration mode, the syntax and behavior is the
same as for IPv4, except that Dell EMC Networking does not support RIP for
IPv6.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#redistribute rip