Dell N1100-ON, Справочное руководство

Страница: 1732 / 2332

Layer 3 Routing Commands
1732
Example
The following example enables administrative mode of OSPF in the router
(active).
console(config)#ipv6 router ospf
console(config-rtr)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPFv3 Configuration
mode to configure the exit overflow interval for OSPF. It describes the
number of seconds after entering Overflow state that a router will wait before
attempting to leave the Overflow State. This allows the router to originate
non-default AS-external-LSAs again. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
exit-overflow-interval seconds
no exit-overflow-interval
• seconds — Exit overflow interval for OSPF (Range: 0-2147483647)
Default Configuration
0 is the default value for seconds.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the exit overflow interval for OSPF at 100
seconds.
console(config)#ipv6 router ospf
console(config-rtr)#exit-overflow-interval 100