Dell N1100-ON, Справочное руководство

Страница: 1269 / 2332

Layer 3 Routing Commands
1269
Command Mode
BGP Router Configuration mode
User Guidelines
By default, a neighbor-specific default has no MED and the Origin is IGP.
Attributes may be set using an optional route map. A neighbor-specific
default is only advertised if the Adj-RIB-Out does not include a default
learned by other means, either from the default-information originate (BGP
Router Configuration) command or a default learned from a peer. This type of
default origination is not conditioned on the presence of a default route in
the routing table. This form of default origination does not install a default
route in the BGP routing table (it will not appear in the show ip bgp
command), nor does it install a default route in the Adj-RIB-Out for the
update group of peers so configured (it will not appear in the show ip bgp
neighbors advertised-routes command).
Origination of the default route is not subject to a prefix filter configured
with the command distribute-list prefix out (BGP Router Configuration) .
A route map may be configured to set attributes on the default route sent to
the neighbor. If the route map includes a match ip-address term, that term is
ignored. If the route map includes match community or match as-path
terms, the default route is not advertised. If there is no route map with the
route map name given, the default route is not advertised. The VLAN
interface must also be specified if a link-local address is specified.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10
default-originate
neighbor default-originate (IPv6 Address Family
Configuration)
To configure BGP to originate a default IPv6 route to a specific neighbor, use
the neighbor default-originate command in IPv6 Address Family
configuration mode.