Dell N1100-ON, Справочное руководство

Страница: 389 / 2332

Layer 2 Switching Commands
389
checked until the carriage return is entered. In some cases, the user may
need to enter special characters, most often in a string parameter such as a
password or a label. Special characters are one of the following characters
(`! $ % ^ & * ( ) _ - + = { [ } ] : ; @ ' " ~ # | \ < , > . / ) or a blank. In
these cases, it may be necessary to enclose the entire string in double or
single quotes for the command line parser to properly interpret the
parameter. . The command line buffer parses up to the maximum number
of command line characters possible in the port-range parameter.
• port-type—Shows all interfaces of the specified type.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration, Interface Range and Interface modes
User Guidelines
Commands under the interface range context are executed independently on
each active interface in the range. If the command returns an error on one of
the active interfaces, it does not stop executing commands on other active
interfaces.
If a range of interfaces is specified using the dash notation, the beginning
range number (to the left of the hyphen) must be less than or equal to the
last number (to the right of the hyphen).
Example
The following example shows how gigabitethernet ports 5/0/18 to 5/0/20 and
3/0/1 to 3/0/24 are ranged to receive the same command.
console(config)# interface range gigabitethernet 5/0/18-20,Gi3/0/1-24
console(config-if-range)#
The following example shows how all gigabitethernet ports can be configured
at once.
console(config)# interface range gigabitethernet all
console(config-if-range)#
The following examples demonstrate various valid interface ranges:
console(config)#interface range gigabitEthernet 1/0/1-20