Dell N1100-ON, Справочное руководство

Страница: 1602 / 2332

Layer 3 Routing Commands
1602
Example
console(config-if-vlan3)#ipv6 pim bsr-border
ipv6 pim bsr-candidate
Use the ipv6 pim bsr-candidate command to configure the router to
announce its candidacy as a bootstrap router (BSR). Use the
no
form of this
command to stop the router from announcing its candidacy as a bootstrap
router.
Syntax
ipv6 pim bsr-candidate vlan vlan-id hash-mask-len [priority][interval]
no ipv6 pim bsr-candidate vlan vlan-id
• vlan-id — A valid VLAN ID value.
• hash-mask-len — The length of a mask that is to be ANDed with the group
address before the hash function is called. All groups with the same seed
hash correspond to the same RP. For example, if this value is 24, only the
first 24 bits of the group addresses matter. This allows you to get one RP
for multiple groups. (Range 0–128 bits).
• priority — The priority of the candidate BSR. The BSR with the higher
priority is preferred. If the priority values are the same, the router with the
higher IP address is the BSR. (Range: 0–255).
• interval—The interval at which candidate rendezvous point
advertisements are sent.
Default Configuration
The router will not announce its candidacy by default.
The default hash mask length is 126 bits.
The default priority is 0.
The default C-RP advertisement interval is 60 seconds.
Command Mode
Global Configuration mode