Dell N1100-ON, Справочное руководство

Страница: 814 / 2332

Layer 2 Switching Commands
814
• add vlan-list — List of VLAN IDs to add. Separate nonconsecutive VLAN
IDs with a comma and no spaces. Use a hyphen to designate a range of
IDs.
• remove vlan-list — List of VLAN IDs to remove. Separate nonconsecutive
VLAN IDs with a comma and no spaces. Use a hyphen to designate a range
of IDs.
• tagged — Sets the port to transmit tagged packets for the VLANs. If the
port is added to a VLAN without specifying tagged or untagged, the
default is untagged.
• untagged — Sets the port to transmit untagged packets for the VLANs.
Default Configuration
Untagged.
Command Mode
Interface Configuration (Ethernet and port channel) mode
User Guidelines
Use this command to change the egress rule (for example, from tagged to
untagged) without first removing the VLAN from the list.
It is possible to configure the general mode VLAN membership of a port
while the port is in access or trunk mode. Doing so does not change the
VLAN membership of the port until it is configured to be in general mode.
Example
The following example shows how to add VLANs 1, 2, 5, and 8 to the allowed
list.
console(config)#interface gigabitethernet 1/0/8
console(config-if-Gi1/0/8)#switchport general allowed vlan add 1,2,5,8
tagged
switchport general ingress-filtering disable
Use the switchport general ingress-filtering disable command in Interface
Configuration mode to disable port ingress filtering. To enable ingress
filtering on a port, use the no form of this command.