Dell Force10 TeraScale C Series, Справочное руководство

Страница: 691 / 1640

IPv6 Access Control Lists (IPv6 ACLs) | 691
deny udp
c e s
Configure a filter to drop UDP packets meeting the filter criteria.
Syntax deny udp { source address mask | any | host ipv6-address } [ operator port [ port ]] { destination
address | any | host ipv6-address } [ operator port [ port ]] [ count [ byte ]] | [ log ] [ monitor ]
To remove this filter, you have two choices:
• Use the no seq sequence-number command syntax if you know the filter’s sequence number
or
• Use the no deny udp { source address mask | any | host ipv6-address } { destination
address | any | host ipv6-address } command.
Parameters
Defaults Not configured.
Command Modes ACCESS-LIST
source address
Enter the IPv6 address of the network or host from which the packets were sent
in the
x:x:x:x::x
format followed by the prefix length in the
/x
format.
Range: /0 to /128
The
::
notation specifies successive hexadecimal fields of zero.
mask
Enter a network mask in /prefix format (
/x
).
any
Enter the keyword
any
to specify that all routes are subject to the filter.
host ipv6-address
Enter the keyword
host
followed by the IPv6 address of the host in the
x:x:x:x::x
format.
The
::
notation specifies successive hexadecimal fields of zero
operator (OPTIONAL) Enter one of the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports
port port
(OPTIONAL) Enter the application layer port number. Enter two port numbers
if using the
range
logical operand.
Range: 0 to 65535
destination address
Enter the IPv6 address of the network or host to which the packets are sent in
the
x:x:x:x::x
format followed by the prefix length in the
/x
format.
Range: /0 to /128
The
::
notation specifies successive hexadecimal fields of zero.
count
(OPTIONAL) Enter the keyword
count
to count packets processed by the
filter.
byte
(OPTIONAL) Enter the keyword
byte
to count bytes processed by the filter.
log
(OPTIONAL) Enter the keyword
log
to enter ACL matches in the log.
Supported on Jumbo-enabled line cards only.
monitor
(OPTIONAL) Enter the keyword
monitor
to monitor traffic on the
monitoring interface specified in the flow-based monitoring session along with
the filter operation.