Dell Force10 TeraScale C Series, Справочное руководство

Страница: 1325 / 1640

Security | 1325
deny udp
e
Configure a filter to drop UDP packets meeting the filter criteria.
Syntax deny udp { source mask | any | host ip-address } [ operator port [ port ]] { destination mask | any
| host ip-address } [ operator port [ port ]] [ count [ byte ]] | log ] [ order number ]
To remove this filter, you have two choices:
• Use the no seq sequence-number command syntax if you know the filter’s sequence number
or
• Use the no deny udp { source mask | any | host ip-address } { destination mask | any |
host ip-address } command.
Parameters
Defaults
Not configured.
Command Modes
TRACE LIST
Related
Commands
source
Enter the IP address of the network or host from which the packets were sent.
mask
(OPTIONAL) Enter a network mask in /prefix format (/x).
any
Enter the keyword
any
to specify that all routes are subject to the filter.
host ip-address
Enter the keyword
host
followed by the IP address to specify a host IP address.
operator
(OPTIONAL) Enter one of the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports
port port (OPTIONAL) Enter the application layer port number. Enter two port numbers if
using the
range
logical operand.
Range: 0 to 65535
destination Enter the IP address of the network or host to which the packets are sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x).
count
(OPTIONAL) Enter the keyword
count
to count packets processed by the filter.
byte
(OPTIONAL) Enter the keyword
byte
to count only bytes
log
(OPTIONAL) Enter the keyword
log
to have the information kept in a Trace-list
log file.
order number
(OPTIONAL) Enter the keyword
order
followed by a number from 0 to 7 as the
order number.
deny Assign a trace list filter to deny IP traffic.
deny tcp Assign a trace list filter to deny TCP traffic.