4 .
To Install the Turbo 601 into the Adapter IIsi, align the board over the
A d a p t e r ’s processor upgrade slot as shown below. Press the connectors
t o gether with both hands until the board is fully seated.
Figure 3- Connecting the Turbo 601 to the processor upgrade slot
5 .
Locate the empty connector on the motherboard. With the rear of the
Macintosh facing you, the empty connector is located in the lower ri g h t
hand corner of the machine (re fer to fig u re 2). This is where you will con-
nect the Turbo 601 Adapter.
6 .
Align the adapter over the empty motherboard PDS connector. Gently push
it into the slot until it is fully seated.
Figure 4 – Installing the Turbo 601 Adapter
7 .
Install the case cove r. Be sure that the V-shaped tabs inside the case cove r
align over the Adapter IIsi to secure the Adapter.
28
