22
4 .
With the heat sink side of the Turbo 601 facing the power supply, align the
b o a rd ’s connector over the 120 pin accelerator slot on the motherboard .
G e n t ly push the card down until it is fully seated.
Installing the Turbo 601
Testing the installation
You have installed the Turbo 601. M a ke sure all connections are tight. You mu s t
n ow test the installation and install the softwa re.
Please read all of this section before you test the installation.
Plug the power cord into the back of the Macintosh. Tu rn the Macintosh on.
You should hear the customary “BONG”. If you do not hear the “BONG”, go to
the next page .
YES! I hear the “BONG”.
1 . Tu rn the power off and re m ove the power cord from the Mac.
2 . Replace the case cover and screw. Attach all cables you have re m oved.
N ow you are re a dy to install the softwa re. Please go to Chapter 5, “Installing the
Turbo 601 Softwa re .”
N OTE: If you hear the new PowerPC bong and the Mac does not boot pro p e rly,
clear the parameter RAM by holding down the -Option-P-R keys simu l t a n e o u s ly
while the computer is starting up. (Make sure the Caps Lock key is not pre s s e d . )
