CTC Union EcoZenith i350 H, Руководство по установке и обслуживанию

Страница: 67 / 116

67
CTC EcoZenith i350
11.6.1 Operation CTC EcoZenith i350
This menu displays current temperatures and
operational data. The first figure is the actual operational
value, with the value in brackets being the setpoint
which the heat pump is trying to achieve.
Status
Shows operating status. The various operating statuses
are:
-> DHW
Hot water (DHW) is produced.
-> HC
Heat is produced for the heating circuit (HC).
-> Pool
Heat is produced for the pool.
-> Off
No heating takes place.
DHW tank °C 49/45 (55)
Displays hot water temperatures in the tank: upper part
and lower part. The value in brackets is the setpoint
(stop temp.).
DHW °C 54 (50)73
Display of current temperature, current set point and
current energy amount.
If no hot water is drawn then no temperature is shown,
just the set point.
Degree minute -1000
Shows current heat loss in degree minutes.
Electric power kW
Shows the output from the immersion heater (0 to 11.9
kW).
Current L1/L2/L3
Shows the system’s total current consumption at
the various phases L1/L2/L3, provided that three
current sensors (accessories) have been fitted to the
unit’s incoming cables. If the current sensors are
not identified, only the phase with the highest load is
displayed. If the current exceeds the main fuse size,
the boiler automatically switches down a power step
to protect the fuses, for example, when several high-
consumption appliances are being used in the house.
Operation data
Stored oper data
Compressor
Heating circuit
Status DHW
DHW tank °C
49/ 45 (55)
DHW ºC 54 (55)
Degree minute -1000
Electric power kW 0.0
Current L1/L2/L3 0.0
Diff func. Pump/ ºC Off 30
Pool ºC 0 (22)
DHW circulation Off
External heat source Off 50
Ext. Boiler Stby 21
i
“Degree minutes” refers to the
product of the cumulative heat loss in
degrees (°C) and the time measured
for this in minutes.