WHEEL BRAKE ASSEMBLIES
Rear Brake Cables
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 6-19
6
3. Route cable towards the rear of vehicle and over to the driver’s side I-beam and secure with wire ties so
that the brake cable does not touch the brake equalizer
.
•
For Turf 6 and Carryall 6 vehicles, the cable should also pass over the brake equalizer rods. On the Turf
6 and Carryall 6 gasoline vehicle, the cable should also pass over the accelerator rod.
•
For Turf 2, Carryall 2 and Carryall 2 Plus vehicles, the cable should pass over the inside I-beam
.
4. Route cable along I-beam towards front of the vehicle and secure as shown
•
For Turf 2 and Carryall 2 electric and all Turf 6 and Carryall 6 vehicles, route cable through hole in I-
beam crossmember.
5. Route brake cable between the shock support (8) and brake cable guide bracket (7)
. Secure brake cable retainer clips (5) with a bolt (4) and nut (6)
.
6. Install brake cable through the front spindle brackets and install E-clip (1)
7. Install brake cable clevis onto brake lever arm and install clevis pin (3) and a new cotter pin (2)
8. Adjust brakes as described in this section for the appropriate vehicle.
REAR BRAKE CABLES
Read WARNING on page 6-1.
REMOVAL
1. Chock wheels to keep vehicle from unintentionally moving.
2. Release parking brake if latched and loosen equalizer retaining nuts (1) on equalizer rod (2) to slightly
loosen brake cables (3) (
.
Figure 6-31 Brake Equalizer
OFF O
N
OFF O
N
FLOORBOARD
REMOVED FOR
CLARITY
8
6
9
TYPICAL
2 PLACES
TYPICAL
2 PLACES
17
10
18
Содержание CARRYALL 1 2000
