Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 52 / 136

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment
Page 5-2 2000 Turf/Carryall Vehicle Maintenance and Service Manual
5
PEDAL GROUP ADJUSTMENT
Read WARNING on pages 5-1 and 5-2.
1. ADJUST BRAKE PEDAL HEIGHT
1.1. Chock wheels and release park brake. Lift rear of vehicle and place jack stands under the axle
tubes to support the vehicle.
1.2. To provide slack in the brake cables, loosen the equalizer retaining nuts (2 and 3) on the equalizer
rod (1) (Figure 5-1, Page 5-2).
1.3. For four-wheel brake vehicles only: loosen the front brake equalizer rod (Figure 5-1a, Page 5-2) .
1.4. Loosen the brake stop jam nut (31), then relieve pedal pressure on the stop by pushing down
slightly on the pedal. Next, adjust the brake stop bumper (22) up or down (Figure 5-2, Page 5-3) .
Adjusting the bumper upward decreases distance between pedal and floorboard. Adjusting the
bumper downward increases distance between pedal and floorboard. Proper brake pedal height
is 5-3/4 ±1/4 inch (14.6 ±.6 cm)
(Figure 5-3, Page 5-3) .
1.5. Tighten the jam nut (31) to 8 ft-lb (9.5 N·m) (Figure 5-2, Page 5-3) .
ELECTRIC VEHICLES ONLY:
• TO AVOID UNINTENTIONALLY STARTING THE VEHICLE, DISCONNECT BATTERIES AS
SHOWN
(FIGURE 1-2 OR 1-3, SECTION 1, PAGE 1-3) .
• AFTER DISCONNECTING BATTERIES, DISCHARGE THE CONTROLLER AS FOLLOWS:
- TURN THE KEY SWITCH TO ON AND PLACE THE FORWARD/REVERSE HANDLE IN THE
REVERSE POSITION.
- SLOWLY DEPRESS THE ACCELERATOR PEDAL AND KEEP IT DEPRESSED UNTIL THE
REVERSE WARNING BUZZER CAN NO LONGER BE HEARD. WHEN THE BUZZER STOPS
SOUNDING, THE CONTROLLER IS DISCHARGED.
Figure 5-1 Loosen Equalizer Rod Nuts Figure 5-1a Loosen Rear Equalizer Rod Nuts
WARNING
1
2
3
2