Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 38 / 136

BODY AND TRIM Seat
Page 4-2 2000 Turf/Carryall Vehicle Maintenance and Service Manual
4
SEAT
To preserve seat appearance clean regularly with mild soap or detergent applied with a sponge or soft cloth.
Use a soft bristle brush to clean areas that are especially soiled. Use the following guidelines:
Light Soiling – A solution of 10% liquid soap and warm water applied with a soft, damp cloth is recom-
mended. A soft bristle brush may be used if necessary. Wipe off any residue with a water dampened cloth.
For Difficult Stains:
- Dampen a soft, white cloth with a solution of 10% household bleach (sodium hypochlorite) and 90% water.
Rub gently to remove stain, then rinse with a water dampened cloth to remove bleach concentration.
- For more difficult stains, perform previous procedure using full-strength bleach; or allow bleach to
puddle on affected area for approximately 30 minutes. Rinse with a water dampened cloth to remove
any remaining bleach concentration.
FRONT BODY REPAIR
STRESS LINES OR STREAKS
Repeatedly flexing the front body may cause white stress lines or streaks in the finish. To remove them:
1. Hold a heat gun 12 inches (30 cm) away from the affected area, with the gun on its lowest heat setting.
2. Slowly wave the heat gun back and forth over the affected area until the streak fades.
3. It may be necessary to move the gun closer to the body to fade the streak, but under no circumstance
should the gun be held closer than 6 inches (15 cm) to the body.
MINOR IMPACT DAMAGE/DEFORMATIONS
Minor impact damage in the front body can be repaired using a procedure similar to the one used to remove
stress lines. To remove deformations resulting from minor impact damage:
1. Hold a heat gun 12 inches (30 cm) away from the affected area, with the gun on its lowest heat setting.
2. Periodically remove the heat gun and bend the body, using a push block, in the opposite direction of the
deformation.
3. Continue heating and bending the body until the original shape returns. Under no circumstance should
the gun be held closer than 6 inches (15 cm) to the body. See preceding CAUTION.
MINOR SCRATCHES AND SURFACE BLEMISHES
For minor scratches or blemishes in the ArmorFlex body that do not penetrate the finish:
1. Thoroughly clean the effected affected area using a strong, non-abrasive detergent and hot water, then
clean with Ultra-Kleen
®
Solvent Cleaner to remove any oil-based contaminants.
2. Lightly buff imperfection with a clean, soft cloth or buff pad. Do not use any kind of polishing compound
on monocoat finished body assemblies.
3. Wax the entire body part to restore luster and weather protection.
• TO PREVENT DAMAGE TO THE VEHICLE WHEN REMOVING DIFFICULT STAINS OR HEAVY
SOILING, REMOVE THE SEAT BOTTOM FROM THE VEHICLE FIRST.
• HOLDING HEAT GUN TOO CLOSE TO BODY COULD MELT BODY OR DAMAGE FINISH.
CAUTION
CAUTION