Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 79 / 136

WHEEL BRAKE ASSEMBLIES Brake Shoe Installation (Self-Adjusting Brakes)
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 6-7
6
2. Install the shoe retainer clip. Compress clip while turning retainer pin into position (Figure 6-13, Page 6-6) .
3. Attach the springs onto the trailing shoe already installed. Then hold the leading shoe next to the trail-
ing shoe, correctly oriented, and attach the springs to it (Figure 6-14, Page 6-6) .
4. While maintaining spring attachment on both shoes, position tips of leading shoe in the mounting slots
and then push shoe into place. Hold shoe in position and install retaining clip (Figure 6-15, Page 6-7) .
5. After the shoes are installed, move them together up and down and side to side to make sure that they
will easily slide approximately 1/4 to 3/8 inch (6.3 to 9.5 mm) without binding. Make sure the shoes are
positioned vertically so that the tips of the shoes are positioned flush at the top with the top surfaces of
the wedge shapes on the shoe mounting blocks as shown
(Figure 6-16, Page 6-7) .
6. Place a flat blade screwdriver under the adjusting arm and raise arm off of the adjusting wheel. While
holding the arm up, turn the wheel upward until it stops (Figure 6-17, Page 6-7) . Remove the screwdriver.
7. Install axle shaft (2) into axle tube and install retaining ring (1) (Figure 6-3, Page 6-3). See following
WARNING and CAUTION.
Figure 6-15 Install Leading Shoe
• CLEAN ANY RESIDUAL OIL FROM THE EXPOSED END OF THE AXLE SHAFT AND FROM THE
OIL SEAL AREA PRIOR TO INSTALLING THE AXLE SHAFT.
Figure 6-16 Slide Shoes
Figure 6-17 Turn Adjusting Wheel
(Self-Adjusting Brakes)
After attaching springs to trailing shoe, insert tips
of leading shoe into slots in shoe mounting block (A)
and adjust assembly (B). Push leading
shoe down into position.
LEADING SHOE
TRAILING
SHOE
FR
ON
T O
F
VE
HIC
LE
B
A
NOTE
After shoes are installed,
slide them up and down
together approx. 1/4 in. to 3/8 in.
to be sure they do not bind.
Position shoe tips so that
that they are flush at the
top with the top surfaces of
the wedge shapes on the shoe
mounting block.
TIPS
While holding adjusting arm
up with screwdriver, turn
adjusting wheel upward
until it stops.
ADJUSTING
WHEEL
ADJUSTING
ARM