Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 89 / 136

WHEEL BRAKE ASSEMBLIES Brake Cluster Removal and Installation
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 6-17
6
FRONT BRAKE CLUSTER REMOVAL
1. Place chocks at rear wheels, loosen lug nuts on front wheels and lift the front of the vehicle with a chain
hoist or floor jack. Place jack stands under the round tube crossmember of the frame to support vehicle.
2. Release park brake.
3. Loosen the equalizer retaining nuts (1 and 6) on the front equalizer rod (2) to slightly loosen the brake
cable (Figure 6-28, Page 6-16, Detail B) .
4. Remove the front wheels and then the brake drums.
5. Remove cotter pin (17) and clevis pin (16) from brake cable (Figure 6-27, Page 6-15) .
6. Remove dust cap (6) on hub and bearing assembly (Figure 6-29, Page 6-17) .
7. Remove cotter pin (5) and hex nut (7) from spindle shaft (Figure 6-29, Page 6-17) .
8. Remove hub and bearing assembly from spindle shaft. Remove four bolts (22), cone washers (21), lock
washers (20) and hex nuts (19) that mount the brake assembly to the spindle (Figure 6-27, Page 6-15) .
9. Remove brake cluster assembly from spindle.
FRONT BRAKE CLUSTER INSTALLATION
1. Install in reverse order of disassembly. Use bolts (22), cone washers (21), lock washers (20) and hex
nuts (19) to mount brake assembly (Figure 6-27, Page 6-15) .
2. Tighten bolts to 30 ft-lb (41 N·m). Adjust brakes as previously described in this section for the appropri-
ate vehicle. Use new cotter pins when reconnecting brake cables.
Figure 6-29 Front Spindle Assembly
6
11
10
1
2
3
TYPICAL
4 PLACES
4
5
9
8
7