Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 115 / 136

STEERING AND FRONT SUSPENSION Front Wheel Bearings and Hubs
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 7-23
7
FRONT WHEEL BEARINGS AND HUB INSTALLATION
1. Pack the wheel bearings (5) and hub cavities, and lubricate cups (7) with wheel bearing grease or
chassis lube. Make sure the grease is forced between the rollers (Figure 7-25, Page 7-23) .
2. If bearing cups (7) were removed, press new ones in squarely against stops in the hub (Figure 7-25,
Page 7-23) .
3. Install the wheel bearings (5) into the hub and install a new seal (6), with the metal edge toward the hub
(Figure 7-25, Page 7-23) . See following NOTE .
4. Install the hub assembly (4) and flat washer (8) on the spindle and start the spindle nut (3) (Figure 7-
25, Page 7-23) .
5. Tighten the spindle nut until the hub is hard to turn, then back the nut (3) off until the hub turns freely.
Install a new cotter pin (2) (Figure 7-25, Page 7-23) .
6. Check front wheel free play. See page 7-22.
7. Install the dust cap (1) (Figure 7-25, Page 7-23) .
8. Repeat the procedure for the opposite wheel.
9. Install the wheels and then finger tighten the lug nuts.
10. Lower the vehicle and finish tightening lug nuts (using a crisscross pattern) to 55 ft-lb (74.6 N·m).
Figure 7-25 Front Wheel Bearings and Hub
• ALWAYS INSTALL NEW CUPS WHEN NEW BEARINGS ARE INSTALLED.
• APPLY GREASE AROUND DUST SEAL INNER LIP BEFORE INSTALLATION.
• WHEN THE COTTER PINS ARE BENT, MAKE SURE THEY DO NOT CONTACT THE HUB OR
DUST CAP.
6 5
7
7
5 8
3
1
2
4
NOTE
NOTE
NOTE