Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 49 / 136

BODY AND TRIM Tailskirt
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 4-13
4
TAILSKIRT
TAILSKIRT REMOVAL
1. Remove two thread-forming screws (5) from tailskirt (4) and lift tailskirt from vehicle frame (Figure 4-5,
Page 4-11 or Figure 4-6, Page 4-12) .
TAILSKIRT INSTALLATION
1. Insert upper edge of tailskirt (4) under, and in front of, back edge of rear body (Figure 4-5, Page 4-11
or Figure 4-6, Page 4-12) .
2. Align holes in tailskirt (4) with holes in vehicle frame. Position tailskirt flush against frame (Figure 4-5,
Page 4-11 and Figure 4-6, Page 4-12) .
3. Install two thread-forming screws (5) in tailskirt and tighten to 55 in-lb (6.215 N·m) (Figure 4-5, Page 4-
11 or Figure 4-6, Page 4-12) .
FLOOR MAT
FRONT FLOOR MAT REMOVAL
1. Remove the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group .
2. Remove horn and/or dimmer switch if equipped.
3. Remove the top edge of the floor mat from the overlapping flange under the dash.
4. Lift the mat from the vehicle.
FRONT FLOOR MAT INSTALLATION
1. Install the floor mat in the reverse order of removal.
2. Install the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group.
REAR FLOOR MAT REMOVAL – TURF 6 AND CARRYALL 6 ONLY
3. On the driver or passenger side of the vehicle, gently pry the edges of the floor mat and pull the floor
mat in the direction of the front of the vehicle, so that it is no longer under the lip of the body located
directly behind the floor mat.
4. Slightly bend the floor mat on each side of the vehicle to free it from the center body assembly located
in front of the floor mat.
5. Lift the floor mat from the vehicle.
REAR FLOOR MAT INSTALLATION – TURF 6 AND CARRYALL 6 ONLY
1. Install the floor mat in the reverse order of removal.
BUMPER
BUMPER REMOVAL
1. Remove four locknuts (10), six flat washers (11), four phillips bolts (12), and mounting plate (9) from
rear bumper (8) (Figure 4-6, Page 4-12) .
2. Lift bumper from vehicle.
BUMPER INSTALLATION
1. Install the rear bumper in the reverse order of removal. Tighten nuts to 65 in-lb (7.3 N·m) (Figure 4-6,
Page 4-12) .