Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 77 / 136

WHEEL BRAKE ASSEMBLIES Brake Assembly Cleaning (Self-Adjusting Brakes)
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 6-5
6
2. Remove the rubber boot from backing plate and wipe with a clean damp cloth.
3. Lubricate the slide (1) and slide plate (2) with dry moly lubricant (Club Car Part No. 1012151) on both
sides of the backing plate. After lubricating, work the slide back and forth to ensure it slides smoothly
and easily
(Figure 6-8, Page 6-5) . Reinstall rubber boot onto backing plate.
4. Use a small brush to carefully apply a liberal amount of white lithium NLGI #2 grease (Dow Corning
BR2-Plus or equivalent) on each of the six raised bosses on brake backing plate (Figure 6-9, Page 6-
5) . See preceding WARNING.
5. Use a small brush to carefully apply a liberal amount of white lithium NLGI #2 grease (Dow Corning
BR2-Plus or equivalent) to each end of both brake shoes and into the slots in the brake shoe mounting
block as shown
(Figure 6-10, Page 6-5). See preceding WARNING
.
• APPLY GREASE CAREFULLY WHEN PERFORMING THE FOLLOWING STEPS. DO NOT ALLOW
ANY GREASE TO GET ONTO THE FRICTION SURFACES OF THE BRAKE SHOE PADS.
FAILURE TO HEED THIS WARNING COULD CAUSE DIMINISHED BRAKE PERFORMANCE,
POSSIBLY RESULTING IN PROPERTY DAMAGE OR SEVERE PERSONAL INJURY.
Figure 6-7 Remove Adjuster Wheel Figure 6-8 Lubricate Slide
Figure 6-9 Grease Raised Bosses Figure 6-10 Grease Shoes
WARNING
1
2
3
1
2
Lubricate slide (1) and slide
plate (2) with dry moly
lubricant. Then work the
slide back and forth.
BOSSES
BOSSES
Use a brush to
apply a liberal amount
of white lithium NLGI #2 grease
to each of the six rasied bosses.
Use a brush to apply a
liberal amount of white
lithium NLGI #2 grease
to the ends of the brake
shoes and in the shoe
mounting slots as shown.