Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 103 / 136

STEERING AND FRONT SUSPENSION Rack and Pinion
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 7-11
7
5. If the needle bearing (7) is damaged, the steering box assembly (Club Car Part No. 101878302) must be
replaced (Figure 7-12, Page 7-10) .
6. Install pinion (8) and bearing (9) assembly into the housing (6) (Figure 7-12, Page 7-10) . Make sure the
rack gear teeth will mesh with the gear teeth on the pinion. The rack may need to be rotated slightly
while lightly tapping on the pinion-bearing assembly with a rubber mallet.
See following CAUTION .
7. Install the internal snap ring (11) (Figure 7-12, Page 7-10) .
8. Using a socket to apply pressure evenly, press in a new dust seal (Figure 7-13, Page 7-11).
9. Apply a small amount of grease to the rack guide (13) where it comes into contact with the rack (17)
(Figure 7-12, Page 7-10) .
10. Place a few drops of Loctite
®
222 to the threads of the screw (16) (Figure 7-12, Page 7-10) .
11. Install the rack guide (13), pressure spring (14), and screw (16). The screw should be threaded in until
a rotational torque of 10 in-lb (1.13 N·m) is achieved (Figure 7-12, Page 7-10) .
• DO NOT FORCE THE PINION-BEARING ASSEMBLY INTO THE HOUSING. THE GEAR TEETH
OR THE SMALL BEARING COULD BE DAMAGED.
Figure 7-13 Press In Dust Seal Figure 7-14 Rack and Pinion Adjustment
Figure 7-15 Rack and Pinion Resistance
CAUTION
DUST SEAL
15/16 DEEP WELL
SOCKET
16
15
1
2
25
VISE
3/8 INCH
1/4 DRIVE
DEEP WELL
SOCKET