Canon imageRUNNER ADVANCE 6055 Series, Руководство по обслуживанию

Страница: 847 / 1406

8
8
8-65
8-65
Service Mode > COPIER > ADJUST > ADJ-XY
Service Mode > COPIER > ADJUST > ADJ-XY
COPIER > ADJUST > ADJ-XY
ADJ-Y-DF Adj img pstn in DADF mode:horz scan[Frt]
Lv.1 Details To adjust the image reading start position in horizontal scanning
direction at DADF reading.
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is incremented by 1, the image position moves to the
rear side by 0.1mm.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range 2 to 202
Unit 0.1 mm
Default value 102
STRD-POS Adj read pstn in DADF mode: front side
Lv.1 Details To adjust the reading position at DADF reading (front side).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -100 to 100
Unit 0.1 mm
Default value 0
Related service mode COPIER> FUNCTION> INSTALL> STRD-POS
ADJ-X-MG Adj img ratio in book mod:vert scan[frt]
Lv.1 Details To make a fine adjustment of image magnification in vertical
scanning direction at copyboard reading.
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is incremented by 1, the image magnification changes
by 0.01%.
+: Enlarge
-: Reduce
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -50 to 50
Unit 0.01%
Default value 0
COPIER > ADJUST > ADJ-XY
ADJY-DF2 Adj img pstn in DADF mode:horz scan[bck]
Lv.1 Details This service mode can be used for the model with Duplex Color
Image Reader Unit-C1 only.
To adjust the image position of back side in horizontal scanning
direction at simultaneous duplex reading.
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is incremented by 1, the image position moves to the
rear side by 0.1mm.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range 56 to 220
Unit 0.1 mm
Default value 124
T-8-25