Canon imageRUNNER ADVANCE 6055 Series, Руководство по обслуживанию

Страница: 657 / 1406

6
6
6-81
6-81
Troubleshooting > Making Initial Checks > c. Manual Download and Update (On-site Update from Service Mode)
Troubleshooting > Making Initial Checks > c. Manual Download and Update (On-site Update from Service Mode)
6. The firmware is applied to the device. The device is automatically restarted when the
firmware is successfully applied.
7. When the device is restarted, confirm the version of the firmware.
1). Press [Check Counter Key] button on the control panel.
2). Press [Check Device Configuration] button.
3). Confirm if the updated firmware version corresponds to [Controller Version].
Now the firmware is successfully updated in the method of “Manual Download and Update”.
CAUTION:
Firmware update will not be triggered when any of the following jobs remains in the
queue.
-Print
-Scan
-Fax (except I-FAX; this function is enabled for I-FAX only during Print/Scan
operation)
See the section of "Wait for EOJ (end of job) Function" under “Limitations and
Cautions”, “Updater” of Chapter 2 “Technology” of this manual for more detailed
NOTE:
To contacts registered for E-mail notification on UGW, the E-mail is sent from UGW
upon completing firmware update.
c. Manual Download and Update (On-site Update from
Service Mode)
The figure below shows the operational flow of “Manual Download and Update”.
STEP 2
Update using
Updater
STEP 1
Download using
Updater
STEP 1: Download using Updater
The firmware can be downloaded from CDS to the device using Updater.
1. Start [Service Mode] at Level 1.
1). Press [Setting/Registration (User mode)] button on the control panel.
2). Press [2] and [8] buttons at a time on the control panel.
3). Press [Setting/Registration (User mode)] on the control panel.
4). [Service Mode] screen is shown.
2. Press [Updater] button.
F-6-157
F-6-158