Canon imageRUNNER ADVANCE 6055 Series, Руководство по обслуживанию

Страница: 424 / 1406

4
4
4-103
4-103
Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Assembly Grid Wire
Parts Replacement and Clearning > Image Formation System > Replacing the Primary Charging Assembly Grid Wire
10) Cut the extra length of the Charging Wire with nippers.
11) Loosen the 4 screws and tighten the screw until the tension of the Grid Wire is uniformed.
Be careful not to deform (bend) the Charging Assembly.
Screws
Screw
Motor Unit
turning over
12) Tighten the loosened 4 screws.
Screws
Be sure to check the following items.
• No bend or twist is found with the Grid Wire.
• The wire is set evenly spaced apart. (The Grid Wire is fitted into the groove of the
Block.)
F-4-103
F-4-104
13) Remove the Shield Plate (Left) and pinch the Grid Wire from the left side to clean it on the
left side with lint-free paper moistened with water.
CAUTION:
• The frame of the Primary Charging Assembly may be distorted, so be careful not to
remove both Left and Right Shield Plates simultaneously.
14) Shift the Primary Charging Wire Cleaners (Left and Right).
15) Tighten the 2 screws.
Primary Charging
Wire Cleaners (Right)
Primary Charging
Wire Cleaners (Left )
Screws
F-4-105
F-4-106