Canon imageRUNNER ADVANCE 6055 Series, Руководство по обслуживанию

Страница: 1006 / 1406

9
9
9-9
9-9
Installation > Unpacking
Installation > Unpacking
5) Take out the 2 Slope Plates stored at the right side of the Pallet and remove the 2 pins
which are secured at the back of the Slope Plate with tape.
6) Turn around the 2 Slope Plates to install as shown in the figure, and then fit the pin-holes of
the pallet with the pin-holes of the Slope Plates to put the 2 pins into the holes.
Pin
Slope Plate
7) Hold the handles at the right side of the host machine, and then, while supporting the
corner of the host machine, fit the casters to the center of the Slope Plate to slowly bring
the machine down.
CAUTION:
Be careful not to make the casters off from the Slope Plate.
Handle
Handle
F-9-8
F-9-9
8) Remove tapes on the exterior surface of the host machine.
NOTE:
Do not remove 2 tapes for tags and a tape for the Filter Cover at this step. These tapes
will be removed later on.
F-9-10
9) Close 4 Handle Covers.
10) When installing the Upright Control Panel at the same time, install it before installing
the Reader Unit. (Refer to "Installation Procedure" included in the Upright Control Panel.)
11)
When installing the Reader Unit at the same time, install it before installing the Main
Body. (Refer to "Installation Procedure" included in the Reader Unit.)