Cambium Networks cnWave 5G Fixed, Руководство по эксплуатации и устранению неисправностей

Страница: 79 / 85

General Troubleshooting Procedures 79
How to hardware reset a BTS to factory default?
If the BTS fails in a field (site) and if it is not possible to access the BTS using the web interface due to
loss of IP address or other reasons, then you must execute a process to recover the BTS. The process
offers several options on which part of the configuration can be kept or the entire BTS can be reset to
factory defaults.
To reset the BTS to factory defaults, perform the following steps:
1. Execute a short power cycle of the BTS. At the power source, you must do a simultaneous power
OFF and power ON.
2. Using a PC, open a web browser and access the default IP address
192.254.1.1
to view the Radio
Recovery Console page of the BTS (for example, as shown in Figure 60 ).
Figure 60:
The Radio Recovery Console page - BTS
Table 9 lists and describes the parameters required for resetting the BTS to factory defaults.
Table 9: Parameters in the Radio Recovery Console page for BTS
Parameter Description
Boot Selection
Reset Configuration Resets the entire BTS configuration back to default
settings. This implies that you must reconfigure all the
parameters for the BTS, including the IP address.