Cambium Networks cnWave 5G Fixed, Руководство по эксплуатации и устранению неисправностей

Страница: 48 / 85

Operational Procedures for BTS 48
When the reconfiguration of parameters is done, the CPE must reconnect and register back with
the BTS. This operation may take a few minutes to complete.
Note
The Radius server must be running for the CPE to get its entire configuration.
Reset CPE to factory defaults including the IP address
To reset the CPE to factory defaults including the IP address, perform the following steps:
1. From the main C100 dashboard page, navigate to Tools > Configuration.
The Configuration page appears.
For more information on logging in to the C100 UI, refer to the Accessing the C100 UI section.
2. Deselect the Local Management Access check box in the Do Not Reset parameter.
This action implies that all the CPE configurations are reset to factory defaults including the local
management IP address.
When this check box is deselected (unticked), a warning message appears as shown in Figure 37 .
This warning message indicates that the local management IP address will be set to the default
192.254.1.1/24 following the reboot. When the Enable Reboot check box is selected, the
CPE reboots.
Figure 37: Factory defaults specific CPE parameters
It is necessary to reconfigure the list of operating frequencies (as listed in Table 1 ) for the CPE to
reconnect with the BTS.
When the reconfiguration of parameters is done, the CPE must reconnect and register back with
the BTS. This operation may take a few minutes to complete.
Note
The Radius server must be running for the CPE to get its entire configuration.
Importing or exporting configuration – No reboot
required
The Configuration page in the B1000 UI allows you to import a saved configuration or export a BTS
configuration for backup (restore). This Import feature exports or imports the date model configuration