Cambium Networks cnWave 5G Fixed, Руководство по эксплуатации и устранению неисправностей

Страница: 47 / 85

Operational Procedures for BTS 47
Note
You must also reconfigure the local management IP address to use SNMP and
manage the system.
Resetting CPE to factory default configuration - Reboot
required
The Configuration tab on the Tools page of the C100 UI allows you to reset the CPE to factory default
settings. Using the C100 UI, you can perform the following configurations:
l
Reset the CPE configuration to factory defaults with no change to the local management IP
address, as described
here .
l
Reset the CPE configuration to factory defaults including the local management IP address, as
described
here .
Reset CPE to factory defaults with no change to the IP address
To reset the CPE to factory defaults with no changes to the IP address, perform the following steps:
1. From the main C100 dashboard page, navigate to Tools > Configuration.
The Configuration page appears.
For more information on logging in to the C100 UI, refer to the Accessing the C100 UI section.
If the Local Management Access parameter is ticked, then all the CPE configurations are reset to
factory defaults except for the local management IP address.
2. Select the Enable Reboot check box.
A warning message appears as shown in Figure 36 . This warning message indicates that a reboot
is necessary to apply the configuration change. Then, the CPE reboots.
Figure 36:
CPE factory defaults specific parameters
It is necessary to reconfigure the operating frequency list (as listed in Table 1 ) for the CPE to
reconnect.