Buell 2009 XB Series, Руководство по обслуживанию

Страница: 468 / 712

6.4 IGNITION/HEADLAMP KEY SWITCH
GENERAL
The automatic-on headlamp feature provides increased
visibility of the rider to other motorists. Be sure headlamp
is on at all times. Poor visibility of rider to other motorists
can result in death or serious injury. (00030b)
Switch positions are explained in Table 6-11 .
NOTE
The key locks the ignition system and is removable in both the
LOCK and P positions. The P position is located counterclock-
wise from the LOCK position and allows the rider to remove
the key while leaving the lights on. When the key is placed in
the P position, several indicator markers are or can be activ-
ated. Refer to
Table 6-12 .
IG
N
IT
IO
N
OFF
ON
PU
SH
ZADI
L
O
C
K
P
1
2
3
4
5
sm00359
1. ON position
2. OFF position
3. PUSH DETENT
4. LOCK position
5. PARKING LIGHT position
Figure 6-2. Ignition/Headlight Key Switch
Table 6-11. Ignition Key Switch Positions
REMOVE
KEY
LAMPS IGNITION LABEL
Yes Off Off OFF
Yes See note and
Table 6-12 .
Off P
No On ON
Yes Off Off LOCK
Table 6-12. Indicator Markers
ON P ITEM
On On Headlight position marker lamps
(European models only)
Can be
activated Off Headlight high beam
On Off Headlight low beam
On Off Instrument module illumination lamps
Can be
activated Off Stop lamp
Can be activated Front and rear turn signals
Can be
activated Cannot be
activated Horn
On Off Aux power outlets
FIREBOLT
TOOL NAME PART NUMBER
SNAP-ON TAMPER-RESISTANT T45
TORX DRIVER FTXR45E
Removal
1. Remove seat.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
2. Disconnect negative battery cable.
3. Cut cable strap holding ignition switch, fuse block and right
handlebar switch wires.
4. Disconnect ignition switch connector [33].
5. See Figure 6-3 . Remove cable straps attached to the
upper fork clamp.
6. Remove air cleaner cover. See 2.38 INTAKE COVER .
7. See Figure 6-4 . Remove steering stem pinch fastener (2).
8. Remove upper fork clamp pinch fasteners (1).
9. Hold or brace the lower fork clamp and remove steering
stem capnut (3).
10. Remove the upper fork clamp (4) from forks.
11. See Figure 6-6 . Use SNAP-ON TAMPER-RESISTANT
T45 TORX DRIVER (Part No. FTXR45E) to remove igni-
tion switch fasteners (3) securing ignition switch (4) to
upper fork clamp. Slide ignition switch out of upper fork
clamp.
HOME
6-8 2009 XB Service: Electrical