Buell 2009 XB Series, Руководство по обслуживанию

Страница: 63 / 712

1.15 THROTTLE CABLE
THROTTLE CABLE ADJUSTMENT
Be sure that steering is smooth and free without interfer-
ence. Interference with steering could result in loss of
vehicle control and death or serious injury. (00371a)
With engine running, turn handlebars through full range of
travel. If engine speed changes during this maneuver, turn
engine OFF and adjust throttle cables as follows:
1. See Figure 1-44 . Loosen cable adjuster lock (5) on each
cable.
2. Turn adjusters (4) in direction which will shorten cable
housings to minimum length.
3. Point front wheel straight ahead. Twist throttle control grip
to fully open position; hold in position.
4. Turn adjuster on throttle control cable (2) until throttle cam
stop touches stop plate. Tighten cable adjuster lock (5)
on throttle control cable adjuster; release throttle control
grip.
5. Turn handlebars fully to right. Turn adjuster on idle control
cable (3) until end of cable housing just touches the cable
guide.
6. Twist and release throttle control grip a few times. Throttle
plate must return to idle position each time throttle grip is
released. If this is not the case, turn adjuster on idle control
cable (shortening cable housing) until throttle control
functions properly.
7. Tighten cable adjuster lock on idle control cable. Recheck
operation of throttle control.
3
2
5 4
1
sm00101
1. Rubber boot
2. Throttle control cable
3. Idle control cable
4. Cable adjuster
5. Cable adjuster lock
Figure 1-44. Throttle Cable Adjuster
HOME
2009 XB Service: Maintenance 1-41