Buell 2009 XB Series, Руководство по обслуживанию

Страница: 344 / 712

3
4
5
2
1
sm03437
1. 1.50 in. (38.1 mm)
2. 1.00 in. (25.4 mm)
3. 5.50 in. (139.7 mm)
4. 1.135-1.145 in. (28.83-29.08 mm)
5. 1.262-1.272 in. (32.05-32.31 mm)
Figure 3-130. Pinion Shaft Inner Race Installation Tool
Table 3-31. New Component Specifications
SPECIFICATIONS FEATURE
MM IN.
3.97408-39.7561 1.5646-1.5652 Outer Race ID
within 0.0051 within 0.0002 Roundness
within 0.0051 within 0.0002 Taper
16 RMS Surface finish
8. See Figure 3-131 . Pull inner race from pinion shaft using
WEDGE ATTACHMENT (Part No. HD-95637-46B) for
CLAW PULLER (Part No. HD-95635-46) with BEARING
RACE REMOVER/INSTALLER (Part No. HD-34902B)
and END CAP (Part No. HD-34902-7). Apply heat to race
to aid removal.
3
1
2
sm00189
1. Bearing race remover/installer
2. End cap
3. Wedge attachment for claw puller
Figure 3-131. Removing Pinion Bearing Inner Race
NOTES
• For necessary dimensions for constructing a press on tool
for the pinion bearing inner race, see
Figure 3-130 .
• The new inner race must be ground by a competent
machinist to OD dimension range for the finished lapped
ID of the outer race. Refer to
Table 3-29 .
9. See Figure 3-132 . Press new inner race on pinion shaft
as shown. When the tool bottoms against the flywheel,
correct inner race location is automatically established.
The finished inner race must meet the specifications in
Table 3-32 .
Table 3-32. Pinion Inner Race Specifications
MM IN. CONDITION
0.005 0.0002 Roundness
0.0051 0.0002 Taper
16 RMS Surface finish
HOME
3-90 2009 XB Service: Engine